Exhaust putty
Exhaust sealant
EXHSTREPCOMPD-CAN-200G
Register now and access more than 125,000 products
- Extremely heat resistant
- Resistant to large temperature fluctuations
- No need to weld or to remove the silencer
For quicker curing, leave the engine to idle at low speed for around quarter of an hour.
The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting with deliberate intent. We ensure the consistent quality of our products. We reserve the right to make technical changes and further develop products.
Datasheets(X)
Ideally suited for repairing cracks and holes in exhaust systems.
- 1. Remove loose dirt and rust using a wire brush.
- 2. Then let the engine run for a short time in order to warm up the exhaust system.
- 3. Wet the area to be repaired and, with wet hands, cover the holes and cracks and surrounding areas with exhaust putty. The paste should be smoothed outwards.
Weight of content | 200 g |
Colour | Grey |
Smell/fragrance | Odourless |
Shelf life from production | 12 Month |
Max. temperature resistance | 800 °C |
Density | 1.99 g/cm³ |
Density conditions | at 20°C |
Last viewed
Concrete screw with hexagon head W-BS/S
Pan head tapping screw, C shape with H recessed head DIN 7981, A4 stainless steel, shape C, with tip
Sheet metal nut, type 2 Open screw-in area
Hexagon screw, type S/A4 — push-through installation DIN 933 A4 stainless steel, with washer, in accordance with DIN EN ISO 7089 (DIN 125), A4 stainless steel
Countersunk screw, type SK/A4 — push-through installation DIN 7991 (ISO 10462) A4 stainless steel, with countersunk washer, A4 stainless steel
Metal insulation dowel W-MDD
Blade connector Uninsulated
Adapter plate Suitable for use in the DS 180 core drill. Required in conjunction with the shoulder support or the second handle
Cordless power tools bag set 18 V M-CUBE ABS/ABH/AWS COMPACT M-CUBE
Flat connector MINI MIC SRS 1.5