Klebfix superglue
Cyanoacrylate structural adhesive, Klebfix
SUPGLU-SUPERFAST-20G
Register now and access more than 125,000 products
NSF registered, class P1, reg. no. 151993
NSF-tested in accordance with NSF/ANSI 61 for use in service water and drinking water
The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products. Please observe the technical data sheet!
Chemical basis | Cyanoacrylate acidic ester |
Colour | Transparent |
Density | 1.06 g/cm³ |
Min./max. viscosity | 20-40 mPas |
Min. combined tension and shear resistance | 14 N/mm² |
Stretch capacity | 2 % |
Max. gluing gap size | 0.1 mm |
Min./max. temperature resistance | -30 to +80 °C |
Min./max. temperature conditions | -30 to 80 °C |
Min./max. processing temperature | 5 to 35 °C |
Silicone-free | Yes |
Solvent-free | Yes |
Shelf life from production/conditions | 15 Month / at room temperature |
Contents | 19 ml |
Weight of content | 20 g |
| Tensile shear strength values in compliance with DIN EN 1465 | |||
| 089309 + 0893090 | 08930900 | ||
| Material | Typical bonding times | Typical tensile lap-shear strength values (N/mm²) | Typical tensile lap-shear strength values (N/mm²) |
| Steel | 60−90 seconds | > 15 | > 15 |
| Aluminium | 60−90 seconds | > 14 | > 14 |
| PA | 20−30 seconds | 8–12 | 8-12 |
| PVC | 20−30 seconds | 10–20* | 10-20* |
| Polycarbonate | 10-15 seconds | 10–20* | 10-20* |
| POM | 30−40 seconds | – | - |
| EPDM | 5-9 seconds | > 10* | > 10* |
| Neoprene | 3−5 seconds | > 10* | > 10* |
| *Material breakage | |||
| Set to the touch after | 089309 + 0893090 | 08930900 |
| Aluminium / aluminium | ≥ 60 seconds | 40-90 seconds |
| SBR / SBR | ≥ 5 seconds | 3-10 seconds |
| Polycarbonate / polycarbonate | ≥ 10 seconds | 8-20 seconds |
| EPDM / EPDM | ≥ 7 seconds | ≤ 25 seconds |
| Curing speed is accelerated by using the activator | ||
Würth Catalogue (1)
Datasheets (1)
Certificates/ Documents (0)
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
